Skip to Content

CC Cylinder Setting Limit Switches

Setting The Retracted Limit Switch

1

Drive the Actuator in the Retract direction with the lift rod unsecured from the load until the bottom limit switch is contacted.

2

Retract the lift rod by hand until it contacts the bottom stop.

3

Rotate one full rotation, allowing for approximately .200 over-travel.

Setting The Extended Limit Switch

1

Drive the Actuator in the Extended direction until the desired limit is achieved.

2

Remove back cover.

3

Loosen the setscrew on the Limit Switch Rod.

4

Adjust the Limit Switch Rod until the Extended Switch is contacted.

5

Re-Tighten the setscrew.

6

Replace Cover.