For position sensing at the input shaft,
the ActionJac™ in-line encoder option may be factory installed between
the motor and motor adapter or Right-Angle Reducer. This low-cost
option requires minimal space. When used with worm gear type cylinders,
it leaves the extension shaft side of the cylinder free for clearance,
for a rotary limit switch, or for coupling to another cylinder.
The In-line encoder’s quadrature output design
allows detection of both speed and direction of shaft rotation.
The ActionJac™ in-line encoder option mounts
to a motor and therefore requires an optional motor mount or right-angle
reducer.
Sensing speed range: 0 -10,000 rpm
Pulse Output: 60 Pulses per revolution
Supply voltage: +12 Volts DC +/-5%
Supply current: 60 mA typical, 115 mA maximum
Output drive capability: 250 mA per channel continuous
Maximum load: 50 ohms per channel
Encoder is face mounted between the motor
and motor mount and will offset the length of the motor .61 inches
for NEMA 56 and 140 frames and .88 inches for NEMA 180 and 210 frames.
|
