Type 2N, End Code 75
End Machining, Medium Journal Typically Used With Duplexed Bearings, Non-Driven Support End, End Code 75
Specifying standard machined ends results in quicker deliveries. The machined ends shown below represent designs that are compatible with common application requirements for either simple. Included in the chart are the locknut and lockwasher identication. These standard ends may be machined and ground to finish size.
NOTE:A Type 1N end is required for single bearing EZZEMOUNT™.
A Type 3K, L, or N end is required for double bearing EZZEMOUNT™.
|Product||Type 2N, End Code 75|
|Nominal Bearing Journal Size||75|
|C Maximum [in]||2.750|
|C Minimum [in]||2.749|
|D Maximum [in]||2.9533|
|D Minimum [in]||2.9527|
|Typical Journal for Single Bearing A [in]||9.14|
|Typical Journal for Single Bearing B [in]||3.64|
|Typical Journal for Single Bearing E [in]||2.914|