Type 2N, End Code 40
End Machining, Medium Journal Typically Used With Duplexed Bearings, Non-Driven Support End, End Code 40
Specifying standard machined ends results in quicker deliveries. The machined ends shown below represent designs that are compatible with common application requirements for either simple. Included in the chart are the locknut and lockwasher identication. These standard ends may be machined and ground to finish size.
NOTE:A Type 1N end is required for single bearing EZZEMOUNT™.
A Type 3K, L, or N end is required for double bearing EZZEMOUNT™.
|Product||Type 2N, End Code 40|
|Nominal Bearing Journal Size||40|
|C Maximum [in]||1.375|
|C Minimum [in]||1.374|
|D Maximum [in]||1.5752|
|D Minimum [in]||1.5747|
|Typical Journal for Single Bearing A [in]||4.55|
|Typical Journal for Single Bearing B [in]||2.37|
|Typical Journal for Single Bearing E [in]||1.812|
Ball Screw Products - Metric Standard Accuracy Ball Screw
Ball Screw Products - Metric Standard Accuracy Ball Screw Assembly
Acme and Lead Screw Products - Rolled Inch Acme Screw
Acme and Lead Screw Products - Inch Acme Screw Assembly
PowerAC 2"-4 LA w/Bronze Nut
PowerAC 2"-4 RA w/Bronze Nut
PowerAC 2"-5 RA w/Bronze Nut
PowerAC 2 1/4"-2 RA w/Bronze Nut