Type 2L, End Code 95

End Machining, Medium Journal Typically Used With Duplexed Bearings, Driven Support End, Without Keyway, End Code 95

Specifying standard machined ends results in quicker deliveries. The machined ends shown below represent designs that are compatible with common application requirements for either simple. Included in the chart are the locknut and lockwasher identication. These standard ends may be machined and ground to finish size.

NOTE:

A Type 1N end is required for single bearing EZZEMOUNT™.

A Type 3K, L, or N end is required for double bearing EZZEMOUNT™.

drawing
Product Type 2L, End Code 95
Product Info
Nominal Bearing Journal Size 95
Dimensions
C Maximum [in] 3.500
C Minimum [in] 3.499
D Maximum [in] 3.7402
D Minimum [in] 3.7394
F [in] N/A
G [in] N/A
Typical Journal for Single Bearing A [in] 11.37
Typical Journal for Single Bearing B [in] 4.37
Typical Journal for Single Bearing E [in] 3.544
Lock Nut AN-19
Lock Washer W-19

Acme and Lead Screw Products - Rolled Inch Acme Screw

Acme and Lead Screw Products - Inch Acme Screw Assembly