Type 2K, End Code 7

End Machining, Medium Journal Typically Used With Duplexed Bearings, Driven Support End, With Keyway, End Code 7

Specifying standard machined ends results in quicker deliveries. The machined ends shown below represent designs that are compatible with common application requirements for either simple. Included in the chart are the locknut and lockwasher identication. These standard ends may be machined and ground to finish size.

NOTE:

A Type 1N end is required for single bearing EZZEMOUNT™.

A Type 3K, L, or N end is required for double bearing EZZEMOUNT™.

drawing
Product Type 2K, End Code 7
Product Info
Nominal Bearing Journal Size 7
Dimensions
C Maximum [in] 0.187
C Minimum [in] 0.186
D Maximum [in] 0.2757
D Minimum [in] 0.2754
F [in] 0.063
G [in] 0.34
Typical Journal for Single Bearing A [in] 1.41
Typical Journal for Single Bearing B [in] 0.93
Typical Journal for Single Bearing E [in] 0.552
Lock Nut 1/4-20
Lock Washer N/A

Ball Screw Products - Inch Standard Accuracy Ball Screw

Ball Screw Products - Inch Standard Accuracy Ball Screw Assembly

Ball Screw Products - Inch Standard Accuracy Twin-Lead Ball Screw

Ball Screw Products - Inch Standard Accuracy Twin-Lead Ball Screw Assembly

Acme and Lead Screw Products - Rolled Inch Acme Screw

Acme and Lead Screw Products - Inch Acme Screw Assembly

Acme and Lead Screw Products - Rolled Inch Twin-Lead Acme Screw

Acme and Lead Screw Products - Inch Twin-Lead Acme Screw Assembly

Acme and Lead Screw Products - Trapezoidal Lead Screw

Acme and Lead Screw Products - Trapezoidal Lead Screw Assembly